Home
SH4xxx Series
Full automatic consolidation test system

@

  • Control and a measurement part are compact.
  • An air supply part is easy for a maintenance with package structure. 
  • Each channel can set up individual load and sampling conditions.
  • Over a long period of time, many stages and load control are made.
  • In an independent measurement input, a response is quick and there is no incorrect measurement.
  • The exaggerated shot just behind load and ringing are not almost. H1204 Picture
  • Since offset of a sensor is taken for every load setup, a drift can be disregarded.
  • Proofreading of load can be performed by being arbitrarily automatic by the user using a proofreading load meter. 
  • Pressure, temperature, and load meter data can be recorded, and the stability of a system can be checked.
  • There is measure of primary air pressure.
  • There is measure of electric power failure and an exchange battery is cheap.
  •  There is little power consumption (W or less [ Being ten channels. 150 ]).
  • There is little air consumption (a part for part a maximum of 70l./[ Being ten channels. ] for an average of 40l./).
  • A function etc. can be reinforced by cheap upgrade.
  • Many of parts of an except, such as a mount and a container, have stock, and quick repair is possible for it.
  • The output of the Japanese Geotechnical Society correspondence can be performed by offer of the PC software for analysis.
  • Since internal control pressure is as low as a maximum of  700kPa, there are a change margin of primary air pressure and an advantage of degradation delay of use parts.

@


HOME By  Hamada Denki Co.,Ltd